At present, the main types of dumpers in China are self-propelled dumpers and trough dumpers. The difference between them is that the self-propelled dumper works by walking with four tires. The trough dumper needs to build a fermentation tank and put the dumper frame on the tank to work.
Before turning over
1. Cannot drive the compost window opener in an area exceeding 5 degrees.
2. Check whether the screw parts of the compost machine are loose. Tighten the loose bolts before starting the organic manure composter.
3. Check that the chain and belt of the compost harvester are loose.
4. Check whether water is added to diesel oil, hydraulic cylinder, diesel water tank and compost water tank.
5. Check whether the battery is powered up. In the process of turning over the pile
In the process of turning over the heap
1. Check whether the materials contain debris such as brick, stone, iron, and glass. Check whether the road surface is smooth, check whether the width of the pile is greater than the width of the running tire. If you exceed the above requirements, please clean up before starting to turn the pile.
2. Flip the compost to the pile. Make sure that the vertical center line of the composter is aligned with the pile and that the horizontal center line of the composter is parallel to the horizontal center line of the pile.
3. Adjust the accelerator to idle state. Lower the roller to its lowest point 3mm above the ground. Switch on the hydraulic clutch, turn the throttle to full, then shift the front gear and start steering with first gear.
4. It is strictly prohibited to stand before and after the compost organizer.
5. Turn off the hydraulic clutch switch at the end of the pile rotation. Raise the roller to the highest point and set the accelerator to run normally.
After turning over
1. Clean the material under the organic manure composter or on the roller.
2. Maintain the compost machine according to the instructions.
3. Turn off the power switch when the compost harvester is not in use.
4. When the machine stops, the motor should not be cut off immediately. Reduce the accelerator to idle and turn off the motor after one minute.